buy celestamine online, buy celestamine online, buy celestamine online, buy celestamine online, buy celestamine online, buy celestamine online.

Servicios

  • paperswrite org
  • CirugAi??as de emergencias
  • HospitalizaciA?n
  • Laboratorio ClAi??nico
  • Unidad de Litotripcia
  • Unidad de ImagenologAi??a
  • Unidad de cuidados intensivos
  • Unidad de endoscopAi??a

A?reas

    • TraumatologAi??a
    • OtorrinolaringologAi??a
    • NeurocirugAi??a
    • CardiologAi??a
    • OftalmologAi??a
    • GinecologAi??a
    • Cuidado intensivo

Purchase sarafem side

 

ClAi??nica santa margarita somos una clAi??nica que presta servicios de salud con cA?lida atenciA?n en un ambiente familiar precautelando el confort del paciente

QUESTION 13
R1 is configured with the default configuration of OSPF. From the following list of IP addresses configured on R1, which address will the OSPF process select as the router ID?
A. 192.168.0.1
B. 172.16.1.1
C. 172.16.2.1
D. 172.16.2.225Correct Answer: A
Explanation
Explanation/Reference:
The Router ID (RID) is an IP address used to identify the router and is chosen using the following sequence:
+ The highest IP address assigned to a loopback (logical) interface.
+ If a loopback interface is not defined, the highest IP address of all active router’s physical interfaces will be chosen.
+ The router ID can be manually assigned
In this case, because a loopback interface is not configured so the highest active IP address 192.168.0.1 is chosen as the router ID

70-331 dumps

QUESTION 14
Refer to the exhibit.
Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)
A. The cable that is connected to S0/0 on RouterA is faulty.
B. Interface S0/0 on RouterB is administratively down.
C. Interface S0/0 on RouterA is configured with an incorrect subnet mask.
D. The IP address that is configured on S0/0 of RouterB is not in the correct subnet.
E. Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.
F. The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA.
Correct Answer: EF
Explanation
Explanation/Reference:
http://www.cisco.com/en/US/docs/routers/access/800/819/software/configuration/Guide/6se r_conf.html

VIDEO

Te invitamos a ver nuestro video institucional, a fin de que Buy himcocid tablet conozcas nuestras instalaciones y nuestros servicios.

Deja un comentario